Radio module for electric flap or actuator 12V
suitable for the following articles:
340707 Actuator 12V controlled for electric exhaust flap
340711 Exhaust flap electric stainless steel 51 mm 2”
340703 Exhaust flap electric stainless steel 63 mm 2.5”
340713 Exhaust flap electric stainless steel 76 mm 3”
Scope of delivery:
1x hand-held radio transmitter
1x radio receiver module
The connections are suitably wired and only need to be connected to a voltage source.
Only available in conjunction with the purchase of suitable servomotors or replacement connection cables.
Notes:
Motorsport accessory, not a replacement or repair part.
No certificate or approval for road traffic.
Only suitable for export, motorsport or show vehicles.
Safety instructions:
- Installation may only be carried out by electronics or mechatronics specialists.
- De-energize before installing or opening the housing.
- Electrical or electronic products can pose a risk of fire or electric shock.
- The control unit is designed for motorsport and show purposes, no approval for road traffic, no TÜV or ABE certificate.
- Use and installation at your own risk, no liability for damage.
- Incorrectly set controls can lead to damage to the engine or vehicle (e.g. closed flap at full load).
- Please ensure that the seals and connections of the product are clean, intact and correctly seated before and after installation, otherwise defects or damage may occur.
- Check the product carefully for integrity before use and installation. If you notice a defect, do not use the product and contact us.
- Only use the product for the specified installation purposes and check its usability before installation or use. If you have any questions, please contact us.
Product safety information
Manufacturer information:
Silbernagel-IT GmbH
Domänenweg 7
Bückeburg, Deutschland, 31675
[email protected] https://www.flapcontrol.de
